Elipta 60w – 12v dc – Potted LED Power Supply in Ground Burial Enclosure

The Elipta 60w – 12v dc – potted LED power supply in ground burial power supply is mounted in a black polycarbonate box and filled with resin, for ground burial. Colour/Finish : Black Dimensions : L 165mm W 145mm D 84mm IP Rating : IP67 Construction : Electronic power supply resin-potted into a black polycarbonate box Input Voltage : 240v input Watts : 60 watts. For use with larger L.E.D.s like 5 and 6 watt MR16 L.E.D. lamps Installation : For surface mounting: Using a slotted screwdriver, rotate each of the 4 quarter-turn corner fixings 90 degrees to the “0” position and remove the lid to reveal the fixing slots in each corner. Secure the transformer to a wall or post with 5mm screws in each corner, or attach to optional transformer mounting stakes. Install the transformer on a wall or post approx. 30cm above ground. For ground burial: Make all connections in T9969 underground joint kit or similar resin-sealed joint. (Boxes with silicon-sealed lids do not protect against ingress of moisture through condensation and capillary action: ordinary silicon sealant does not bond reliably with all enclosure materials.) After burying the transformer and associated junction boxes, lay a paving slab or similar protective material over it, cover with cable warning tape and back-fill hole. NB: Where multiple ground burial transformers are to be installed in an area, allow connection points where possible above ground to allow for isolation in the event of future fault-finding. Connection of transformers to separate cores of a multicore cable may also be considered. Failure to adopt these recommendations may mean difficulty in fault diagnosis in the future and in extending or upgrading the system. Downloads  Product Specification Sheet for T9210GB – Elipta 60w – 12v dc – Potted LED Power Supply in Ground Burial Enclosure